Formax FD 8904B User Manual download pdf (Page 6)



Check the safety devices:

• at the start of each work shift (when operation is sporadic)

• at least once a week in continuous operation

• after each maintenance or repair

Check the safety devices for:

• specied condition • specied location

• safe attachment • specied function

Correct defects before you operate the shredder.

1. Immediately shut down the shredder if defects occur during operation and make sure the defects are

corrected.

2. Do not modify or remove protective devices. Do not switch off protective devices. For safety reasons,

modications of the machine are not allowed.

 Defective safety devices can cause serious accidents. If safety devices are not

working properly, the shredder should immediately be put out of operation.

reach into the cutting system while it is operating; you risk serious injury!

Only when all safety devices are operating correctly can the shredder be used again.



1. Check the  push switch (A) in front of the feeding table:

The shredder must switch off immediately when you press the  and the Emergency Stop

Light (B) must go on.

2. Check the   (B) on

the left of the control panel:

The shredder must switch off immediately

when the button is pushed, and the

Emergency Stop Light must go on.

3. Check the  inside the Cutting

Block Access Door at the top of the shredder

(C). Press the door handle release. Handle will

rotate up. Pull up on handle.

The shredder must switch off immediately

when the door is opened, and the

Emergency Stop Light must go on.

1 2 3 4 5 6 7 8 9 10 11 ... 22 23

No comments

Formax FD 8904B User Manual Page 6