Formax FD 8252CC User Manual download pdf (Page 6)

12 Classic 104.3 08/2011

english

6 Troubleshooting

Paper jam

You have fed in too much paper.

Notice Do not press rocker switch alter-

nately forwards/backwards (

 - 

). Cutting

unit could be damaged.

• Press rocker switch .

 Pa per is pus hed out.

• Se pa ra te pa per stack.

• Press rocker switch .

• Feed in pa per successively.

T

S

WARNING

Dangerous mains voltage!

Switch off the shredder and pull

out the mains plug.

When cleaning only use a soft cloth and a

mild soap-water solution. However, no water

must enter the equipment.

8 Disposal / Recycling

Electrical and electronic old de-

vices contain a variety of valuable

materials, but also hazardous

substances which were required

for function and safety. Incorrect

disposal or handling can be dan-

gerous to your health and the environment.

Never dispose of old devices in the house-

hold waste. Observe the current applicable

regulations and use the collection points for

returning and recycling electric and elec-

tronic devices. Dispose of all the packaging

materials also in an environmentally-respon-

sible way.

Oil the cutting unit when

cutting performance de-

creases or the device

becomes noisy, or every

time you empty the waste

container (Cross cut only):

• Spray special cutting block oil through pa-

per feed opening across the whole width

of the cutting system blades.

• Press automatic start stop control and run

cutting system forwards and backwards

(

 - 

) several times without feeding pa-

per. Paper dust and particles are shaken

off.

7 Cleaning and maintenance

Shredded material container contact

interrupted

 Paper shredder switches off.

• Check whether shredded mate-

rial container is correctly inserted

in bottom frame.

For all other malfunctions, check whether

the motor was overloaded before contacting

our customer service. Let the shredder cool

down for approx. 15 – 20 mins. before using

it again.

Shredded material container full

 Paper shredder switches off.

Notice Empty the cut material container,

immediately because if it is too full, malfunc-

tions can occur in the cutting system.

• Switch equipment off. To do this

tap rocker switch .

• Empty cut material container.

T

1 2 3 4 5 6

Comments to this Manuals

No comments