Formax FD 8904CC User Manual download pdf (Page 11)

Operation

1. Set main switch to ON (page 7). Turn the Key OFF/ON toggle switch on the control panel to the ON position.

2. Press the START button. The conveyor will begin to move in the forward direction.

3. Place the material to be shredded on the feed table, then slide it onto the infeed conveyor belt, in

appropriate stacks. (Up to 650 sheets.)

NOTE: If material is accidentally placed onto the conveyor belt, DO NOT REACH FOR IT. Instead, press the

red STOP button (left side of control panel) or the Safety Stop Bar (front of feed table). When the shredder

stops, press and hold the REVERSE button. The conveyor will operate in reverse, allowing safer access to the

materials. The shredder will stop when the REVERSE button is released. To resume shredding, press STOP

button, then the START button.

Turning off the shredder

1. To shut down the shredder, press the STOP button on the control panel.

2. Turn Key OFF/ON toggle switch on the control panel to the OFF position (to the left).

3. Open the electrical control panel door, and ip the main power switch DOWN to the off position.

Overloading the motor

If the shred capacity of the machine is exceeded (too large a stack of paper, etc), the shredder will stop

automatically. To resume shredding:

1. Push and hold the REVERSE button until the paper or other material backs completely out of the shredder.

2. Press the red STOP button or the SAFETY BAR on the front of the machine, then divide the materials into

smaller stacks.

3. Press the START button. The conveyor and cutting blades will begin to move.

4. Continue shredding, feeding less paper or fewer materials at a time.

Frequent Overloading

If the shredder is repeatedly overloaded, the motor can overheat, which will cause the shredder to switch off

automatically. To resume shredding:

1. Allow the motor to cool down for approximately 20 - 30 minutes before using.

2. Once the motor has cooled sufciently, resume shredding by following standard operating procedure.

NOTE:

To maintain optimum performance and allow constant operation, avoid repeatedly

overloading the shredder. This will prevent time-consuming reversing cycles, and will

provide the highest possible throughput.

Oiling Cutting Blades with automatic EvenFlow Oiling System

The EvenFlow Oiler helps keep the cutting blades in peak operating condition by periodically applying oil to the

blades.

1. To replace the oil bottle, unscrew and remove the cap from a new bottle of oil. Insert the hose and threaded

screw cap. Tighten cap and place bottle in holding bracket on the right side of the shredder.

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 26 27

No comments

Formax FD 8904CC User Manual Page 11