FD 280-10 Heavy Duty Feeder for FD 280 Tabbing System Operator Manual 8/201
5. OPERATION CAUTION ALWAYS TURN ON THE FEEDER AFTER OTHER MACHINES IN THE SYSTEM. 1. Plug the Feeder in to a grounded outlet 2. Turn POWER
Figure 5.1 Feed Hopper 5. Place a stack of pieces between the PAPER GUIDES. a. Remove as much paper curl as possible from the pieces. b.
Figure 5.2 Correctly Loaded Hopper CAUTION IMPROPER STACKING WILL CAUSE JAMS. 6. Turn the POWER SWITCH ON. Amber LED lights on Feeder. If Fee
5.2 Feed Separator Figure 5.3 Feed Separator Adjustments Feed Separators are i
lead edge of the piece will raise up as it feeds. If the gap is too large, the piece will probably feed along with another, double feeding. The ga
6. TROUBLESHOOTING 6.1 Troubleshooting Chart Trouble Cause Solution 1. Feeder not running. POWER SWITCH is off. Turn POWER SWI
7. MAINTENANCE & SERVICE 7.1 Cleaning Wipe dust, debris or contaminants from the Feeder as they accumulate. Use a damp cloth. Keeping the F
TABLE OF CONTENTS 1. INTRODUCTION ... 1 1.1 F
1. INTRODUCTION 1.1 Feeder Description The FD 280-10 Feeder is designed to be used with a variety of printing and forms processing devices. I
CAUTION ALERTS YOU TO ACTIONS WHICH MAY CAUSE DAMAGE TO EQUIPMENT OR WORK FLOW INTERRUPTION. NOTE Draws your attention to an important statement
2. SPECIFICATIONS & REQUIREMENTS 2.1 Specifications Size FD 280-10 - 24" l x 24" h x 19" w Weight 65 lb. Producti
3. POWER CONNECTION WARNING BEFORE PLUGGING THE FEEDER INTO AN OUTLET, CAREFULLY READ THE FOLLOWING INFORMATION ABOUT VOLTAGES AND THE POWER CORD.
4. SET-UP WARNING KEEP LOOSE CLOTHING, TIES, SCARVES AND HAIR AWAY FROM ALL MOVING PARTS. DO NOT PLACE FINGERS OR TOOLS BETWEEN OR NEAR MOVIN
Comments to this Manuals