Formax FD 150 User Manual download pdf (Page 45)

Operating Manual

1/97 41

8.1.3 Imprint Is Too Light

Replace the INK ROLL if the imprint does not improve

after turning the INK ADJUSTMENT KNOB. The INK

ROLL also needs to be replaced if you hear the COVER

knocking. Refer to Figure 8.1 throughout this procedure.

Figure 8.1 -- Ink Roll Installation

NOTE

Before replacing the used INK ROLL, put on the

gloves provided with the new INK ROLL.

1. Open the COVER.

2. Pull out the COTTER PIN.

3. Hold the INK ROLL currently installed in the FD 150.

4. Pull out the AXLE.

5. Discard the used INK ROLL.

6. Hold the new INK ROLL between the sides of the INK

ROLL CARRIAGE.

7. Insert the AXLE, pointed end first, through the holes in

the INK ROLL CARRIAGE.

8. Insert the straight side of the COTTER PIN into the

hole in the pointed end of the AXLE.

1 2 ... 40 41 42 43 44 45 46 47 48

No comments

Formax FD 150 User Manual Page 45